Grace Digital GDI-BTSP200 BT Speakers - Manual (Page 5)

Playback Device Paring Examples :
 iPhone, iPad , iPod : go to SETTINGS > GENERAL > enable BLUETOOTH > select Grace Digital
 Android Phones: go to SETTINGS > WIRELESS & NETWORKS > enable BLUETOOTH > select Grace Digital
 Other Smart Devices: please refer to the User Guide that came with the device
NOTE: enter the pairing code “0000” if prompted
4. Change to an alternate Bluetooth Playback Device when connected
Change between playback devices by turning off the Bluetooth signal in the paired device. Press & hold the
Play/Pause button on the top panel for a few seconds to disconnect the previous Bluetooth device from the
System. The System will restart the pairing sequence.
NOTE: IF pairing is not completed in approximately 2 minutes the speakers will go into power-saving mode.
In this state the Bluetooth LED blinks in red. Press and hold the Play/Pause button to initiate re-pairing.
Wired Audio Connection
STEPS:
1. Connect the playback device to the RCA input interface on the back right rear panel of the right
speaker. Use the RCA to 3.5mm mini cable included with the speaker.
2. Press the source button and the Line in LED lights to indicate the speakers are ready to receive audio.