Clear-Com RM-702 - Manual (Page 19)

R M - 7 0 2 T W O - C H A N N E L R E M O T E
2 - 7
• PROGRAM ENABLE B: Enables program audio channel B when set to
the on position.
• MOM TALK A: Setting the momentary talk A switch to the on position
will disable the latching function of the channel A talk button. In this
mode, the talk button must always be held in continuously while the
operator is talking on channel A.
• MOM TALK B: Setting the momentary talk B switch to the on position
will disable the latching function of the channel B talk button. In this
mode, the talk button must always be held in continuously while the
operator is talking on channel B.
• CALL ON TALK A: If the call on talk A switch is set to the on position,
a call signal will be placed on channel A whenever the talk function is
activated. This can be used to activate any call-activated functions
available on other stations.
• CALL ON TALK B: If the call on talk B switch is set to the on position,
a call signal will be placed on channel B whenever the talk function is
activated. This can be used to activate any call-activated functions
available on other stations.
• INTRPT ANNC: If the interrupt announce switch is set to the on
position, pressing the announce button will disconnect the microphone
from the intercom line(s). This will allow announcements to be made
without being heard over the intercom channels.
• INTRPT EXT IFB: When the hot mic output is connected to
Clear-Com’s IFB system and the interrupt external IFB switch is set to
the on position, pressing a key on the IFB system will disconnect the
selected headset or panel microphone from the intercom line(s). This
allows the RM-702 microphone to be used to cue talent without
affecting intercom line communication.
• LONG LINE A: If a long cable run on channel A is unavoidable and
approaches 1,000 ft. (305 m) or more, set the long line A option switch
to the on position. The ability to set a sidetone null on channel A
depends upon properly setting this switch.
• LONG LINE B: If a long cable run on channel B is unavoidable and
approaches 1,000 ft. (305 m) or more, set the long line B option switch
to the on position. The ability to set a sidetone null on channel B
depends upon properly setting this switch.
• PROGRAM INTERRUPT A: Interrupts the program audio to channel A
while a call signal is sent on channel A (default).
You can change this option so that a talk signal, rather than call sig-
nal, interrupts the program audio on channel A. You do this by re-set-
ting an internal jumper. See the next section, “Re-Setting Program
Interrupt Options,” for instructions.
• PROGRAM INTERRUPT B: Interrupts the program audio to channel B
while a call signal is sent on channel B (default).