1 installing the power supplies, 2 installing the rear panels, Installing the power supplies – Clear-Com HX System Frames User Manual

Page 31: Installing the rear panels

Advertising
background image


4.2.1 Installing the power supplies

The Eclipse HX-Median system’s DC power supplies run on AC mains power.

Two identical Euro Cassette power supplies are provided to ensure that every matrix has
redundant power.

Each of the power supplies must be connected to a dedicated branch of AC mains power.
The matrix will continue to operate even if one of the AC power branches fails.

Clear-Com supplies each matrix with power supplies already installed. When the matrix is
installed connect the power supplies to AC mains power using the IEC power connectors on
the matrix’s rear panel.

A fully equipped Eclipse HX-Median matrix (2 CPU cards, 7 interface cards and 8 interface
modules)

requires 100 - 240 VAC at 50 - 60 Hz with a maximum dissipation of 300W.

4.2.2 Installing the rear panels

The rear panel of the matrix is constructed of modular, individually-installable connector
panels. Each port or expansion card has a corresponding rear-connector panel:

• An MVX-A16 rear panel has 16 RJ-45 connectors.

• E-FIB rear panels have two fiber connectors.

• E-QUE, IVC-32 and LMC-64 rear panels have 11 RJ-45 connectors.

• E-MADI64 rear cards have a MADI fiber connector, MADI input and output coaxial

cable connectors, and a coaxial Video / Word clock input.

Note:

Clear-Com ships each matrix with the required number of rear-connector panels already
installed. Blank rear panels fill unused card slots.

To add a rear panel to the matrix:

1. Remove the desired blank rear panel by loosening the screws and pulling the panel

out. The screws are attached and cannot be removed.

2. Install the new rear panel by sliding the card into the card’s guides at the top and

bottom of the Eclipse HX-Median chassis.

3. Tighten all of the screws on the rear panel.

To remove a rear panel from the matrix:

1. Detach any devices connected to the rear panel’s connectors.

2. Loosen the screws that hold the rear panel to the matrix. The screws are attached

and will not fall off.

3. Remove the rear panel by pulling the panel out.

31

Eclipse HX-Median User Guide

Advertising
This manual is related to the following products: