INTELLINET NETWORK 524995 Wireless 300N Dual-Band USB Adapter User Manual - Manual (Page 22)

mutually authenticate with a new AP by performing a complete LEAP
authentication, including communication with the main RADIUS server.
When a wireless LAN is configured for fast re-association, however,
LEAP-enabled client devices roam from one access point to another
without involving the main server. Using Cisco Centralized Key
Management (CCKM), an access point configured to provide wireless
domain services (WDS) takes the place of the RADIUS server and
authenticates the client so quickly that there is no perceptible delay
in voice or other time-sensitive applications.
Enable Radio Measurement: When this parameter is enabled, the Cisco
AP can run the radio monitoring through the associated CCX-compliant
clients to continuously monitor the WLAN radio environment and
discover any new APs that are transmitting beacons.
Non-Serving Channel Measurements: The Cisco access point can
perform monitoring measurements through the CCX-compliant clients
on the non-serving channels when this parameter is enabled.
Limit [xxx] milliseconds (0-2000): This setting limits the channel
measurement time. The default value is 250 milliseconds.
Turn off RF: Click to turn off the radio; click again to turn it back on.
WMM
This screen enables you to configure WMM (Wi-Fi Multimedia) and
other QoS settings, such as Power Save and Direct Link Setup.
22
CONFIGURATION