INTELLINET NETWORK 524988 User Manual - Manual (Page 37)

37
SYSTEM & NETWORK SETUP
When you select a key format, the number of characters in the key will be displayed.
For example, if you select “64-bit” as the key length and “Hex” as the key format,
you’ll see the message to the right of “Key Format” is “Hex (10 characters),” which
means the length of the WEP key is 10 characters.
Default Tx Key — You can set up to four sets of WEP keys, and designate one as
the default here. NOTE: If unsure which one you should use, select “Key 1.”
Encryption Key 1-4 — Enter WEP key characters here. The number of characters
must be the same as the number displayed n the “Key Format” field. You can
use any alphanumerical characters (0-9, a-z and A-Z) if you select “ASCII” for
the key format. If you select “Hex” as key the format, you can use 0-9, a-f and
A-F. You must enter at least one encryption key here; if you enter multiple WEP
keys, they should not be same.
Enable 802.1x Authentication — IEEE 802.1x is an authentication protocol. Every
user must use a valid account to log in to this router before accessing the wireless
LAN. The authentication is processed by a RADIUS server. This mode
authenticates the user by IEEE 802.1x, but it does not encrypt the data during
communication. If there is a RADIUS server in your environment, enable this
function. Check this box and another sub-menu will appear:
RADIUS Server IP address — Enter the IP address of the RADIUS server.
RADIUS Server Port — Enter the port number of the RADIUS server.
RADIUS Server Password — Enter the password of the RADIUS server.