Waste electrical & electronic equipment, Compliance statements – INTELLINET NETWORK 524988 User Manual User Manual

Page 70

Advertising
background image

70

SECTION NAME

WASTE ELECTRICAL & ELECTRONIC EQUIPMENT

Disposal of Electric and Electronic Equipment

(applicable in the European Union and other European countries with separate collection systems)

This symbol on the product or its packaging indicates that this product

shall not be treated as household waste. Instead, it should be taken to

an applicable collection point for the recycling of electrical and electronic

equipment. By ensuring this product is disposed of correctly, you will help

prevent potential negative consequences to the environment and human health,

which could otherwise be caused by inappropriate waste handling of this product.

If your equipment contains easily removable batteries or accumulators, dispose of

these separately according to your local requirements. The recycling of materials

will help to conserve natural resources. For more detailed information about

recycling of this product, contact your local city office, your household waste

disposal service or the shop where you purchased this product. In countries

outside of the EU: If you wish to discard this product, contact your local authorities

and ask for the correct manner of disposal.

COMPLIANCE STATEMENTS

FCC Class B

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of Federal Communications Commission (FCC)

Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment to an outlet on a circuit different from the receiver.

• Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure set forth for an uncontrolled

environment. To avoid the possibility of exceeding FCC radio frequency exposure

limits, human proximity to the antenna shall not be less than 20 cm (8 inches)

during normal operation. The antenna(s) used for this transmitter must not be co-

Advertising