Attaching multiple autoview 424 units – Avocent 416 User Manual
Page 21
Chapter 2: Installation
15
d.
Highlight and select the Remote User menu selection. Use the
Spacebar to cycle through peripheral types and select the ones
appropriate to your system. Press Enter to select.
Attaching Multiple AutoView 424 Units
NOTE: CIFCM cables are required for cascading.
To cascade multiple AutoView 424 units:
1.
Follow steps 1-5 in the procedure To install an AutoView 424 switch for each
cascaded unit.
2.
Plug the 25-pin “mini-D” connector of your CIFCM input cable into any
available channel port on the rear of your primary AutoView 424 unit.
3.
Plug the 15-pin video connector on the other end of the cable into the port
labeled
on your first cascading AutoView 424 unit. Plug the PS/2 mouse
connector into the port. Plug the remaining 6-pin miniDIN keyboard
connector into the
port.
Figure 2.4: Attaching Multiple Units
AutoView 424
Primary Switch
Secondary Switch
Servers 2-18
Servers 2-18
Server 1