KT&C KPT-SPDN300NUCH - Manual (Page 31)

3. Program and Operation
3.11 Alarm Menu
▲ /▼: move joystick up and down for selecting an item.
◀ /▶: move joystick left and right for moving an item.
▶ / [Open]/ [Near]: move joystick right to select or save settings or go to edit pages.
▶ / [Close]/ [Far]: move joystick to cancel or to exit current menu (Back).
- Enter into {Main Menu}
- Using the joystick [▶], select Alarm Input type (NO/NC).
- Using the joystick [▶], select Alarm Output (On/Off)
- Alarm priority can be set using the joystick [▶],
Change an action/number {Off, Preset, Pattern, Scan, or Tour}.
- Set Alarm action time (Dwell Time): 3~60sec/On, default setting is ‘ON’.
-> Time Out (3~60sec): This is activated during a period of a selected dwell
time when an alarm is triggered.
-> Momentary (On): When an alarm is triggered, the dome camera will
maintain alarm activation continuously, until it is stopped manually
(96+preset or/and changing in alarm menu).
- It is possible to clear saved {Alarm No.xxx}, pressing [Wide] button at a position of
{No.xxx} individually.
- Press [Open] button or use joystick [▶] to save settings.
- Press [Close] button or use joystick to return to previous menu (Back).
* Note
:
In order to call an action (Preset, Pattern, Tour or Scan), you must save Preset, Pattern,
Tour, or Scan first. To pause alarming (about 10sec) temporarily, press [ESC] button or [96+preset]
31
ALARM SETUP
NO. 001 : NOT USED
IN :
OUT :
PRIORITY :
ACTION :
NUMBER :
DTIME :
SAVE : OPEN
BACK : CLOSE
- SET/CLEAR : (TELE/WIDE)