CNB IG1810PF - Manual (Page 41)

XNET Network Box Camera User’s Guide
6. Tips for using XNET/XNET-Wireless
6.1. ALARM-IN and ALARM-OUT
ALARM connectors are used to connect various sensing and alerting devices. Examples of
sensing devices are infrared sensors, motion sensors, heat/smoke sensors, magnetic sensor, etc.
ALARM-OUT is used for connecting alerting device such as loud speaker, flashing light, etc.
Figure 6-1. ALARM-IN/ALARM-OUT Connector
6.1.1. ALARM-IN
e
nes providing on-off switching are connected between “+“ and “-” pins. Figure
6-2 shows the input circuit of “Alarm In”.
Connect the two wires of the sensors to “Alarm In”. The sensor type can be set in Administrativ
mode. Output li
41 of
47