CNB SDF1212 - Manual (Page 33)

33
4-3. PTZF operation
To operate the PTZF functions, connect the controller to the RS-485/422 port on the rear panel.
In the PTZ control setting in the setup menu, user can select or set the protocol type of the camera
which is the same as the one that is installed on the site. If the camera has a specific camera ID, select
the camera ID using Left or Right button.
The PTZ function button is found on the front panel. Once you press the PTZ button, the screen will
appear as in figure 4.3.1. Highlight the item to select and control the cameras by using the UP and
DOWN or LEFT and RIGHT buttons. Please refer to the table 4.3.1. for description.
Figure 4.3.1. PTZF control screen
Button functions in PTZF control
PAN / TILT Use the UP or DOWN button for TILT and LEFT or RIGHT button for PAN of the selected camera.
ZOOM / FOCUS Use the UP or DOWN button for ZOOM in or out and LEFT or RIGHT button for FOCUS
near or far of the selected camera.
INITIALIZE Initialize the PTZ settings of the selected camera.