CognitiveTPG A799 - Manual (Page 5)


TPG-ETHSUG Rev. A 11/07
Ethernet Interface Setup Guide
Ethernet setup commands
The following commands are designed to set the required printer internal parameters for Ethernet operation. The
commands can only be used in the Flash download (boot) mode.
Restore default settings
ASCII US BS NUL
Hexadecimal 1F 08 00
Decimal 1 8 0
Restores the Ethernet settings to the preset values.
Default settings are:
IP address: 192.0.0.192 (in use after boot time-out of two minutes)
Net mask: 0.0.0.0 (default mask of selected IP is used)
Gateway: none
Raw TCP/IP port 9001: active
Telnet Daemon: enabled
LP Daemon: disabled
Bootp: disabled
DHCP: enabled
Inactivity timeout: enabled
Keep alive pings: disabled
Setting IP address
ASCII US BS SOH n1 n2 n3 n4
Hexadecimal 1F 08 01 n1 n2 n3 n4
Decimal 1 8 1 n1 n2 n3 n4
Default: 192.0.0.192
Sets the IP address value specified by the values of n1 to n4.
Setting Net Mask
ASCII US BS STX n1 n2 n3 n4
Hexadecimal 1F 08 02 n1 n2 n3 n4
Decimal 1 8 2 n1 n2 n3 n4
Default: 0.0.0.0
Sets the Net Mask value specified by the values n1 to n4.
Setting the Gateway
ASCII US BS ETX n1 n2 n3 n4
Hexadecimal 1F 08 0 n1 n2 n3 n4
Decimal 1 8  n1 n2 n3 n4
Default: none
Sets the printer to the gateway having the IP address value specified by the values n1 to n4. A gateway, even when the
printer is on another subnet, is not always needed.
The printer initiates no connection and obtains the gateway address from the host packets. Image units must have the
gateway specified to act as client when sending images to hosts on another subnet.