CognitiveTPG A799 - Manual (Page 8)

8 Ethernet Interface Setup Guide
TPG-ETHSUG Rev. A 11/07
Imager-only ethernet setup commands
Set image host address
ASCII US BS FF n1 n2 n3 n4
Hexadecimal 1F 08 0C n1 n2 n3 n4
Decimal 1 8 12 n1 n2 n3 n4
Value of n1 n2 n3 n4: IP address of the host to receive images
Default: 192.0.0.1
Configures the printer with the IP address of the host to receive the images. This is used when the printer is acting as a
client and the host has a server running to receive the images. The gateway must be set to operate in this mode when the
host is on a different subnet.
Set image TCP port
ASCII US BS CR n1 n2
Hexadecimal 1F 08 0D n1 n2
Decimal 1 8 1 n1 n2
Value of n1 n2: n1 Low order byte of port number
n2 High order byte of port number
Default: 9000
Configures the printer with the TCP port to use for image transmission. This is used when the printer is acting as a client
and the host has a server running to receive the images or when the image server is enabled.
Image server
ASCII US BS SI n1
Hexadecimal 1F 08 0F n1
Decimal 1 8 1 n1
n1 = 0: disabled
n2 = 1: enabled
Default: enabled
Enables or disables the internal image server. With this enabled the printer runs a server on the configured port which a
remote host can contact to receive the images.