CognitiveTPG A799 - Manual (Page 6)

 Ethernet Interface Setup Guide
TPG-ETHSUG Rev. A 11/07
Setting raw TCP/IP port
ASCII US BS EOT n1 n2
Hexadecimal 1F 08 0 n1 n2
Decimal 1 8  n1 n2
n1: Low order byte of port #
n2: High order byte of port #
Default: Port = 9001
Sets the port where the printer will look for raw TCP/IP communications. Setting port number to 0 disables raw TCP/IP
communications.
LP Daemon
ASCII US BS ENQ n1
Hexadecimal 1F 08 0 n1
Decimal 1 8  n1
n1 = 0: disabled
n1 = 1: enabled
Default: disabled
Enables or disables the printer LP Daemon. The LP listens on port 515.
Telnet Daemon
ASCII US BS ACK n1
Hexadecimal 1F 08 0 n1
Decimal 1 8  n1
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Enables or disables the printer Telnet server. The Telnet server listens on port 23.
BootP
ASCII US BS BELL n1
Hexadecimal 1F 08 07 n1
Decimal 1 8 7 n1
n1 = 0: disabled
n1 = 1: enabled
Default: disabled
Enables or disables the use of BootP at power-up to obtain an IP address. BootP is a subset of DHCP.