CognitiveTPG CRx - Manual (Page 38)

34
Chapter 2: Getting Started
The output from the self test is described in the table below.
Setting Description Example (Actual settings may vary
from examples listed below)
FW Firmware version and date FW: 195-170-120 V1.20
S/N Printer serial number S/N: P012345678
RAM, FLASH RAM and FLASH size RAM=18MB, FLASH=8MB
Inches Printed Total inches printed Inches Printed: 2911
Printhead Printhead Designation Printhead: KPC108_8T0A1
Printer Settings
Aux. Power Enable 5vdc output through Serial port Aux. Power: OFF
Buffer Reset (1/10sec) Enables or disables the buffer reset timer Buffer Reset (1/10sec): 65535
Comm Communications port configuration values (Baud, Parity, Data
Bits, Stop Bits)
Comm: 9600,N,8,1,OFF
Darkness Darkness setting of printer. First number is factory setting (not
user modifiable). Second number is variable, user modifiable
setting
Darkness: 0 (0)
Energy Offset Adjusts the Energy Density Energy Offset: 0 (0)
Feed Speed Speed at which media is fed using the FEED button Feed Speed : NORMAL
Index Enabled Current state of Indexing. Either enabled or disabled (No Index) Index Enabled
Feed Type Current Indexing mode. GAP, BAR or Notch Feed Type: GAP
DTBAR Index sensor settings for Black Bar indexing in Direct Thermal
print mode
DTBAR: R=56 T=13 G=0
TTBAR Index sensor settings for Black Bar indexing in Thermal Transfer
print mode
TTBAR: R=50 T=15 G=0
DTGAP Index sensor settings for Gap indexing in Direct Thermal print
mode
DTGAP: R=1 T=16 G=0
TTGAP Index sensor settings for Gap indexing in Thermal Transfer print
mode
TTGAP: R=1 T=40 G=0
DTNOTCH Index sensor settings for Notch indexing in Direct Thermal print
mode
DTNOTCH: R=20 T=5 G=0
TTNOTCH Index sensor settings for Notch indexing in Thermal Transfer
print mode
TTNOTCH: R=50 T=1 G=0
No Media (inches) Distance (in inches) label travels before printer either attempts
to recalibrate, or errors out with a red ready light. (Gap indexing
mode only)
No Media (inches): 1
Pitch (dots) Print density in dots per inch Pitch (dots): 200
Present Label When ON, Printer will advance and reverse distance specified
below for each label printed
Present Label: ON
Advance With PRESENTLABEL ON, the distance that a label is advanced, in
hundredths of an inch
Advance: 15
Reverse With PRESENTLABEL ON, the distance that a label is retracted, in
hundredths of an inch
Reverse: 20
Print Mode DT indicates direct thermal printing, TT indicates thermal transfer
printing
Print Mode: DT (DT)
Print Speed Displays the current printing speed setting. Print Speed: HIGHSPEED
Report Level Sets the manner in which the printer reports recoverable errors. Report Level: 2
Shift left: (1/100) inches) Distance the image is shifted to the left, in hundredths of an inch Shift left: (1/100) inches): 0
Text Buffer:
Size Size of the text buffer Size:65535
Overflow Overflow value for the text buffer Overflow: 1024
User Feedback Shows the status of VARIABLE USER_FEEDBACK User Feedback: OFF
Width Default label width (approximate), in hundredths of an inch Width: 425 (864 dots)
Auxiliary Language Secondary Language Processor Aux. Language: NONE