CTI Products CIB Comparator Interface - Manual (Page 23)

CIB Hardware Reference Comparator Wiring Lists
CTI Products, Inc.
68-10854-135
17
7. Comparator Wiring Lists
This section includes wiring lists to help you connect a CIB module to a particular
comparator. If you are using a comparator not shown in this section, refer to
Table 9 for the pinout of connector J1 on the back of the CIB module.
NOTE: When connecting the CIB to your comparator, please follow the settings
specified for jumpers E1A and E1B. Improper setting of these jumpers could
result in improper operation of your comparator display system.
Wiring lists are given for the following comparators:
• TAC page 18
• Spectra TAC page 20
• Digitac page 22
• M/A-Com / Ericsson / G.E. Analog Voter page 24
• JPS SNV-12 Voter page 27
• Doug Hall 4RV/2 Voter page 30
The wiring lists tell you if the CIB J1 pin being connected is Input (I), Output (O)
or Input/Output (I/O). Refer to Figure 2 for a diagram of the CIB’s I/O circuitry.
Wiring lists are included for both Logical Order and Punch Block Order.