Controlled Products Systems Group 1024 - Manual (Page 16)

PN# 3642036534, 02/26/2010 REV. 1
16
3.Securely fasten wires.
‡ Securely fasten wires to ceiling and
wall using insulated staples provided.
– Use insulated staples.
– Staples should be snug only.
‡ If rear cover is attached to power head,
remove it.
‡ On power head:
– Route wall console wires through wire guide on
power head.
– Split and strip ends of wire (Fig. 3-2 on
previous page).
– Insert wire into terminal holes and lightly press in
the orange locking clips above each terminal
hole. (You can use a pencil or small screwdriver
to comfortably press in locking clips.) The white
wire into #1 terminal hole and striped wire into
the #2 terminal hole.
– Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole.
‡ Do NOT install rear cover yet.
4. Mounting.
‡ Fasten wall console to wall with 2 screws
(provided) (Fig. 3-4).
‡ Remove protective backing from "Entrapment"
warning label (Fig. 3-5). The "Entrapment" label
is located in the center of this manual.
– Stick label on wall near wall console.
Insulated
Staple
+ –
P B
Infrared Sensor
1 2 3 4 5 6
FIG. 3-3 Insert wires .
(Power Head With Rear Cover Removed)
1 2 3 4
Terminal
Holes
Locking
Clips
5 6
wire guide
FIG. 3-4 Mounting Wall Console.
Child
can
be p
inned
under
automatic
garage
door.
Death or se
rious injury can result.
‡
Never let
child walk or run under moving door.
.
‡
Neve
r let child use door opener controls.
‡ Always
keep movin
g door in sight
.
‡ If person is pinned, push control
button or use
emergency release.
‡
Te st door opener monthly:
Refer to your owner
s manual
P lace 1
/ -inch object (or 2x4 laid flat) on
f oor
If door fails
o rev
erse on contact
adj
ust opener
If op ener sti
l fails
o revers
e d oor
repair
or replace opener
Do not
remove or pa
nt ov
er this label
Mount wa
l con
rol ou t of chi
d s reac
h (at le
ast 5 fee
t abov
e floor
)
Plac
e next to wa
ll on trol
© 1999
FIG. 3-5 Mounting Entrapment warning label.
3
2
1
Independent Light Control
– Controls door opener lights from inside garage
– Energy-Saver shut-off turns OFF lights 3 minutes after
door activation
Vacation Locking Switch
– LOCK disables controls after
door is completely closed
– UNLOCK allows controls to
work normally
Door Control "Open/Close" Button
– Open and closes door from
inside garage