Chapter 1 about this manual, Purpose of this manual, Reference material – Ampro Corporation Single Board Computer Littleboard 550 User Manual
Page 7: Chapter 1, About this manual, Purpose of this manual reference material
LittleBoard 550
Reference Manual
1
Chapter 1
About This Manual
Purpose of this Manual
This manual is for designers of systems based on the LittleBoard™ 550 single board computer (SBC).
This manual contains information that permits designers to create an embedded system based on specific
design requirements.
Information provided in this reference manual includes:
•
LittleBoard 550 Specifications
•
Environmental requirements
•
Major integrated circuits (chips) and features implemented
•
LittleBoard 550 connector/pin numbers and definition
•
BIOS Setup information
Information not provided in this reference manual includes:
•
Detailed chip specifications
•
Internal component operation
•
Internal registers or signal operations
•
Bus or signal timing for industry standard busses and signals
Reference Material
The following list of reference materials may be helpful for you to complete your design successfully.
Most of this reference material is also available on the Ampro web site in the Embedded Design
Resource Center. The Embedded Design Resource Center was created for embedded system developers
to share Ampro’s knowledge, insight, and expertise gained from years of experience.
Specifications
•
PC/104 Spec Revision 2.5, November 2003
• PC/104-Plus Spec Revision 2, November 2003
For latest revision of the PC/104 specifications, contact the PC/104 Consortium, at:
•
PCI 2.3 Compliant Specifications
For latest revision of the PCI specifications, contact the PCI Special Interest Group Office at: