Impulse MAQ20-940 Configuration - Manual (Page 10)

MAQ
®
20 Configuration Software Tool User Manual
4
Figure 4: Configuration Software Tool, Module Comm Tab
2.2 Module Data Panel:
This tab allows the monitoring of up to 5 different registered modules or up to 5 different addresses
spaces of the same module. First select the module to be monitored using the Module # drop down box,
next select the address to be monitored from the Address drop down box, and last, select the number of
addresses to be monitored using the Read Qty numeric up/down box. An address map listing data
locations can be found in the MA10xx MAQ20 Hardware User Manual for the specific I/O Module being
used. This Module Data Panel also allows the user to write to specific addresses by double-clicking on
the cell that corresponds to the address to be written to. This action opens a new panel where the user
can write the desired value and the number of addresses to write. The starting address of the write panel
will correspond to the address of the cell that was double-clicked on.
2.2.1 Update Options: Poll the I/O modules in Continuous or Single Read mode using the
appropriate radio button.
2.2.2 Update Timer Settings: In Continuous mode, the poll interval can be increased or
decreased using this numeric up/down box.
2.2.3 Update Display Settings: Changes the display of information read from or written to the
I/O modules.
2.2.4 Display Data: Opens a second panel that logs all of the active address spaces.