Atek electronic Secure Password Organizer LG10B - Manual (Page 15)

Logio User’s Manual, page 
using the
button, which can input a total of 31 different characters.
When you are done entering ID1, or if you do not want to enter anything, push
or . Do the same for the ID2 and ID3. Note that if you leave any of user IDs 1, 2,
and/or 3 blank, then when you are adding a new record, Logio will skip them when
you push
. For example, if you set up user IDs 1 and 2 only, pushing (only
with the cursor on line 2 of the screen, and only if there are no existing characters) in
a new record will show the number 1, then your user ID 1, then your user ID 2, and
then number 1 again because you do not have a user ID 3.
7. Set up button tone volume
The screen will display:
Push . The screen will display:
Button tones provide helpful sound feedback when pushing buttons on the Logio
keypad.
Use the
and buttons if you want to change the default “Med” (Medium)
setting to “Off”, “Low”, or “High”.
Push
when you are done. You can always change this setting later by pushing
the setup options button .
8. Set up auto-off time
The screen will display:
Initial Setup