Atek electronic Secure Password Organizer LG10B - Manual (Page 9)

Logio User’s Manual, page 
Initial Setup
IMPORTANT NOTE:
Your Logio automatically turns off after a set period of inactivity to save battery
power and protect against intrusions by other people. The default auto-off time
is one minute. Therefore it is recommended that you first read these entire Initial
Setup instructions (especially the very important “Set up master passcode” section)
before turning on your Logio, otherwise it may turn off while you are reading, and
then you will have to start the initial setup process over. In case you are curious
now, note that as described in this User’s Manual, there is a way to change the
auto-off time both semi-permanently and temporarily, but the former method is only
available as the last step in the initial setup and the latter method is only available
after the initial setup is complete.
1. Remove the protective film from the LCD display
2. Install the battery
The battery is taped to the bottom of the big cavity on the back of the plastic
clamshell package. To install the battery, turn the Logio face down, put your
thumbnail into one of the two curved grooves next to the label, and gently pull out
the battery tray. Turn the Logio and tray over and put the CR2016 lithium coin cell
battery into the tray with the plus sign (+) on top. Make sure the battery sits all the
way down in the tray. Put the tray back into the Logio by angling it slightly so that
one barbed corner goes in first, and then straighten out the tray and gently slide it
all the way in.
3. Turn on your Logio
Turn on by pushing the on/off button
one time.
This message will display on the screen while Logio prepares to take you through
the initial setup:
Initial Setup