Nilfisk-ALTO 748 L - Manual (Page 16)

Page -16- CLARKE TECHNOLOGY Operator's Manual - SCRUBTEC 770 / 784 / 795 SCRUBTEC 770 / 784 / 795 SCRUBTEC 770 / 784 / 795 SCRUBTEC 770 / 784 / 795 SCRUBTEC 770 / 784 / 795
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install The Batteries
The Scrubtec machines use six 6-volt batteries. The
batteries are located in the battery compartment
under the recovery tank.
To Install the batteries, follow this procedure:
1. Turn key switch off.
2. Make sure both tanks are empty.
3. Disconnect the hoses from the recovery tank
(upper tank) & unplug the vac motor and float
switch.
4. Remove the tank support bracket.
5. Remove the recovery tank.
6. Place the batteries in the solution tank as
shown in figures 6a and 6b.
WARNING: Lifting batteries without
help could result in an
injury. Get help to lift the
batteries. The batteries are
heavy.
WARNING: Working with batteries can
be dangerous. Always
wear eye protection and
protective clothing when
working near batteries.
NO SMOKING!
7. Connect the battery cables between
batteries and install long battery cable
assembly as indicated. See figure 6a and 6b.
8. Install the tank, reconnecting hoses and
plugging in vac motor and float switch
connectors. Install tank support bracket.
NOTE: Charge the batteries before using the
machine.
Figure #6a
Figure #6b
38722B
38722B
38722B
38720B 38720B
38722B
38720B
38722B
38722B