Nilfisk-ALTO 748 L - Manual (Page 22)

How To Traverse Machine
NOTE: Put the machine in the slow traverse speed (see
figure #17). Use the machine in an area that has no
furniture and objects until you can do the following:
1. Move the machine in a straight direction, forward and
backward.
2. Stop the machine safely.
3. Move the machine in a straight direction after you turn
the machine.
To move the machine, follow this procedure:
1. Turn the key switch “ON” position.
2. Put the brush switch in the "UP" position.
3. Raise the squeegee.
4. To go forward, push one or both of the yellow forward
switches (see figure #18).
5. To stop the machine, release the yellow forward
switches.
6. To go backward, push in on the white reverse button and
one of the yellow forward switches at the same time (see
figure #19).
7. To turn the machine, push the rear of the machine to the
side.
8. When you stop the machine, turn the key switch "OFF".
How to Clean a Floor
WARNING: Water solutions or cleaning materi-
als used with this type of machine
can leave wet areas on the floor
surfaces. These areas can cause a
dangerous condition for the operator
or other persons. Always put CAU-
TION signs near the area you are
cleaning.
To clean a floor, follow this procedure:
1. Put the water and a cleaning chemical in the clean
solution tank.
2. Turn the key switch "ON". If one touch feature is used,
press the green button and proceed to step 6 (deluxe
models only).
3. Lower the squeegee.
4. Put the brush switch in the "DOWN" position.
5. Adjust the flow of clean solution to the flow desired.
6. Move the machine across the floor in the forward
direction.
7. Make a 180 0 turn.
NOTE: When you make more passes across the floor, let
the brushes clean approximately 5cm of the
area already cleaned by the brushes.
NOTE: During most cleaning procedures, apply and
remove the solution in one operation.
Figure # 17
Figure #18
Figure #19
HOW TO OPERATE THE MACHINE
Page -22- CLARKE TECHNOLOGY Operator's Manual - SCRUBTEC 770 / 784 / 795 SCRUBTEC 770 / 784 / 795 SCRUBTEC 770 / 784 / 795 SCRUBTEC 770 / 784 / 795 SCRUBTEC 770 / 784 / 795