Luminex FLEXMAP 3D Hardware User Manual - Manual (Page 34)

To ensure accurate test results, properly clean and maintain the Luminex ® FLEXMAP 3D ®
system. Read and follow all instructions in this section. Perform adequate maintenance and
cleaning to avoid inaccurate results and potential hazards. To facilitate your maintenance
process, print out and use the maintenance logs found
General Maintenance Precautions
Observe the following general maintenance precautions, which were explained in more detail
in :
Personnel who use, maintain, or clean the FLEXMAP 3D instrument should be trained in
standard laboratory safety practices and should follow those practices when handling the
instrument.
Samples and waste fluid can contain biohazardous material. Where exposure to
biohazardous material, including in an aerosol form, exists, follow appropriate biosafety
procedures, use personal protective equipment, and use ventilation devices.
Do not remove the cover of the FLEXMAP 3D instrument under any circumstances.
Avoid contact with moving parts. Disconnect the instrument from the power source when
the procedure instructs you to do so.
Daily Maintenance
Chapter 3: Maintenance and Cleaning
23