MAX PJID143 - Manual (Page 15)

15
5. OPERATING
INSTRUCTIONS
1. HOW TO MOUNT / REMOVE THE
BATTERY PACK
• (Fig. T)Before mounting / removing the Bat-
tery pack from the tool, set the Rotational
direction switch(Fig. T 8) at middle posi-
tion, and keep hands away from the Trigger
switch(Fig. T 2).
• Before operation, make sure to check the
Battery pack is securely set in the tool.
Failure to do so may cause serious injury.
1 (Fig. M) When mounting the Battery pack,
insert the Battery pack in the tool so that
the rails of the Battery and the tool fit
each other. Slide the Battery pack to the
end, until the click is heard. The Latch-
es(Fig. M 18) must be returned to the orig-
inal position.
2 (Fig. E) When removing the Battery pack,
remove it from the tool by pushing on its
latches (Fig. E 18) from both sides while
firmly holding the grip of the tool.
2. HOW TO SET AND REMOVE THE
BIT TO THE TOOL HOLDER
• (Fig. U)Before setting / removing the bit to
the tool, keep the fingers away from the
Trigger switch, and remove the Battery
pack from the tool.
<Size of the bit socket>
• Use the bit matched with the screw.
Use only bits (Fig. O 11) shown in (Fig.N). Do not
use other types of bit.
Pull the sleeve protector (Fig. O 1) forward until
it stops and insert the bit into the hexagonal
socket in the anvil until it stops, then release the
guide sleeve.
∗ To remove the bit, reverse the above se-
quence.
• If the sleeve protector does not return to its
original position after the bit has been in-
serted, the bit has not been installed prop-
erly. Insert the bit into the hexagonal
socket in the anvil until it reaches the base
and stops, then make sure that the sleeve
protector returns to its original position.
• Do not use unspecified bits.
An improper bit may fall out during operation or
may not be removed.
3. HOW TO OPERATE THE ROTA-
TIONAL DIRECTION SWITCH
(Fig. P) Seeing the tool as shown in the figure P,
press the Rotational Direction switch (Fig. P 8) to
the right (Fig. P A) to operate the tool clockwise.
Press the switch to the left (Fig. P B) to operate
the tool counterclockwise. Set the switch at the
middle position to lock the tool’s operation. When
the tool is not in use, make sure to set the switch
at middle position.
• Do not operate the Rotational direction
switch during the tool is in operation.
Operating the switch during the tool’s opera-
tion may damage the tool.
WARNING
WARNING
CAUTION
CAUTION
CAUTION
PJID143-2Lang.book 15 ページ ２０１０年６月２４日 木曜日 午後７時１７分