Meriam M4 Series Precision Calibrator Data Logger Manual - Manual (Page 9)

ZM4 Instruction Manual 9R87-B June 2012
9
Measure Mode
Figure 4: Measure Mode Display with All Indicators Shown
Icon or Reference Function
HOLD Values are held on display for reference.
REC Data logging function is ON and calibrator is
recording information.
USB USB cable is connected to the calibrator.
100% Battery life as a percentage value.
10:35 AM Current time display.
P1: Type XXX Pressure Sensor #1, Type, and Full Scale
Range in units selected. See specifications
for further details.
P2: Type XXX Pressure Sensor #2, Type, and Full Scale
Range in units selected. See specifications
for further details. M400 units will have N/A
displayed on the screen.
VI: Mode Voltage/mA Sensor and current operation
mode selected.
▲▼ Indicators for Maximum and Minimum
measured or limit values.
T Tare indicator.
50.0% Simulation value as a percent of full scale
/ Indicator for auto simulation mode:
ramp(shown), step or paused.
RANGE Unit is operating with a soft or hard over
range limit. See over and under range table.
Hold Function Key to toggle the hold function of
the displayed values.
Mn/Mx Function Key to reset the displayed
maximum and minimum values.