Micromod Micro-DCI: 53MC5000 Training Manual User Manual
Page 126
Advertising
Training Manual
F-CIM Lab
9 - 12
• After the program is erased, the controller will display the MicroDCI logo and the
line ERASE at the bottom as shown in the next figure.
Figure 9 .7.
FCIM ERASE
The BUILD Mode: The BUILD mode allows us to enter or modify an existing F-CIM
program.
To Build an F-CIM program:
7.
Enter Step 00
• Press F2 to scroll to BUILD. While BUILD is displayed at the bottom of the
display, press the F3 key. See the next figure:
Advertising