Mobi Technologies 70055 MobiCam Digital DL - Manual (Page 10)

INSTALLATION & SETUP
The MobiCam Digital DL Monitor is designed to be powered by either batteries
or the AC/DC adaptors. You can also purchase a rechargeable battery pack (item
# 70077) available at getmobi.com or retailer to use with your monitor.
Using AC/DC adaptor:
•
Plug the connector of the AC adaptor into the DC Jack on the unit (fig.
9 & 17).
• Plug the power cord into an outlet.
• Switch the power plug to the ON position (fig. 7 & 16)
• The power indicator lights will illuminate once the units are turned on
(fig. 4 & 12)
Using Batteries:
•
Remove the battery door at the bottom/back of each unit by loosening
the child-safe screw and sliding the cover downward to release.
• Both units can use 1.5 volt AA size batteries. (Always use batteries of
the same brand and age, alkaline batteries are recommended)
Insert 4 AA batteries into camera and 5 AA batteries into the monitor.
• Replace the covers by aligning the tabs with the tab holes and tighten
ing the child-safe screws.
Please note that the life of batteries is limited. Therefore, when monitoring over
long periods and, in particular, overnight, it is recommended to use AC adaptors
for both the camera and the monitor unit.
Warning:
1.
Do not mix old and new batteries.
2. Do not mix alkaline, standard or rechargeable batteries
3. Remove the batteries during long periods of non-use.
4. Use only the AC adaptors supplied with the package.
Optional Battery Pack:
The Monitor on your system has a built-in battery recharging circuit. Make sure
you only use the optional battery pack (Item # 70077), as standard rechargeable
batteries will not recharge.
Note: Camera unit does not recharge batteries.
8