Mobi Technologies 70008 Recam Remote Monitoring - Manual (Page 26)

- 26 -
Customize Motion Detection
Motion Sensitivity
Motion Sensitivity defines a value in percent of the changes. It compares the last image and the current image
and counts changes.
A large value means more sensitivity. You can check your settings with the colored bar below the sensitivity track
bar: green - no motion event, red - there is motion.
Check Motion each
Select the frequency of motion detection from the drop-down list.
Motion Area
You can specify an area of movement detection. The parts of image, which are outside the defined Motion Area,
are removed from the active motion detection.
For example, you can use this option if you want to remove cars moving outside the window.
To define Motion Area:

Click to select the Define Motion Area check box.

Click the Motion Area button.

Drag and resize the rectangle, which defines the area where monitored motion appears. The less area
you specify, the motion will be detected more accurately. You can use Arrow keys to move rectangle or
Shift + Arrows to resize.
Warming Time
Defines a delay in seconds before the program starts to detect motion. Increase this value if your camera needs
time to adjust focus and stabilize picture.
Motion Actions
When a motion is detected, ReCam can perform the following actions:
Start FTP Uploading when motion detected
If a motion is detected, ReCam starts FTP uploading.
If the Stop FTP Uploading After check box is checked, the uploading will be stopped in specified number of
seconds.
Send Email
Click to select the Send Email check box if you want to receive a email when motion is detected.
Click the Email Settings button to customize the email parameters.
Outgoing Mail Server
This is the mail server that your e-mail is sent through. If you are unsure of this setting, have a look at the
settings of your E-Mail client and see what you have set for your SMTP server.
Sender
Enter your e-mail address.
Recipient
Enter the e-mail address of who will receive the e-mail message. If there are a few recipients, type the e-mail
address of each recipient, separating addresses with a comma or semicolon ( ; ).
Subject
Enter the subject of e-mail message.
Message
Enter contents of the message.