MPM MOD-02 - Manual (Page 28)

28
GB
B. Container. The container section is a middle part of a vacuum cleaner, used as a conta-
iner to collect dust and dirty water. This section is attached to engine’s set with clamps. A
container for a shampoo and clean water (washing liquid) is located under the water filter
container.
B1 – Container
B2 – Water filter tank
B3 – Water filter sponge
B4 – Water filter tube
B5 – Rubber gasket
B6 – Clamps
B7 – Locks sockets
B8 – Sucking inlet
C. Washing liquid container. Washing liquid container has a shampoo and clean water.
When the pump works, shampoo and water are taken from the tank. Liquid going from the
container through a hose is sprayed. Liquid container is situated between a water filter con-
tainer and a base with wheels.
C1 – Washing liquid container
C2 – Short washing hose
C3 – Short washing hose connector
C4 – Indicator of water level
D. A base with wheels
D1 – Base
D2 – Wheels
D3 – Lock
E. Hose. This section includes a sucking hose with a handle and sucking tubes. Sucking
attachment is connected with container’s set through putting the hose into sucking inlet.
Sucking tubes are jointed with each other and then connected to a handle. The handle has
washing liquid feeder and sucking power regulation. The hose can be put on engine’s set with
the use of hanger.
E1 – Element fixing a sucking hose
E2 – Element fixing a washing hose
E3 – Washing liquid hose
E4 – Clamps
E5 – Sucking hose
E6 – Liquid feeder lever
E7 – Sucking power regulation
E8 – Handle
E9 – Sucking tubes (2)
E10 – Hanger
mod-02_instrukcja.indd 28 27-01-09 21:52:23