MPM MOD-02 - Manual (Page 34)

34
GB
Put the washing liquid container on a base with wheels (drawing 14).
Put a container in a liquid tank, engine’s set on the container and lock the clamps (drawing 3). -
Connect a short washing hose (C2) to washing liquid tank (C1) (drawing 16) and to the -
connector (A3) at the back of engine’s set (drawing 15).
Connect a long washing hose (E3) to liquid feeder lever (E6). Connect an element fixing -
washing hose (E2) to the connector (A3) on engine’s set.
Connect liquid feeder lever (E6) with sucking hose handle (E8). -
Connect a long washing hose (E3) with sucking hose (E5) and sucking tubes (E9) using -
the clamps.
Connect washing tip (F1) to sucking tubes or directly to the handle. -
A tip for delicate cleaning (G1) can be connected only to the handle. To wash carpets, rugs -
and to wash a floor use a normal tip. To wash armchairs, sofas, curtains, car upholstery etc.
use a tip for delicate wet cleaning, attaching it directly to the handle.
Put a plug in the socket. -
In order to switch on a pump press a pump switch (A1) and put a mixture of water and -
shampoo on a cleaned surface.
Water and shampoo (washing liquid) are pumped from a liquid container with a pump and -
sprayed on cleaned surface with a tip. The liquid gets into fibres and dissolve even perma-
nent dirt. Wait at least three minutes to let shampoo to be absorbed.
Switch off the pump with a switch (A1) -
Press a vacuum cleaner switch (A2) in order to start sucking function and move the tip on -
the floor surface. When washing upholstery, suction of dirty water and spraying of a liquid
mixture may take place at the same time
If foam starts flowing from the container (B1) switch off the device immediately and empty the -
container from dirty water. Also, check a quantity of washing liquid in a liquid container (C1).
When the container is full of dirty water, the float will automatically block suction and the -
engine will start to work louder. In such case, switch off the vacuum cleaner and the pump
immediately, take a plug from a socket, take a sucking hose (E5) from a handle (E8), and
washing liquid hose (E3). Take an engine’s set off and empty the container.
If you want to clean hard floors, for example covered with tiles, marble etc put hard floors -
attachment (F2) on a washing tip (F1).
With the use of tip (F1) you can suck for example water which has leaked from a dishwa- -
sher or washing machine or water left after fridge or freezer defrosting.
Attention: Use of the vacuum cleaner that will be not-compliant with the instructions above,
may cause production of too big quantity of froth, which will overflow through HEPA filter.
If such thing happens, switch the device off, take the plug from a socket, empty the water
container, clean water filter tank and dry it. Next take also HEPA filter out and dry it. Wash
a foam filter located in float section and leave it to dry. Wait about 2 hours to let froth from
the engine dry off.
CLEANING AND MAINTENANCE
Before e - ach cleaning, make sure that the device is disconnected from mains.
After use empty, clean and dry a container. Dump and dirt may be a cause of unpleasant -
scent.
Before removing dirt and contaminated liquid disconnect a sucking hose, disengage clamps -
mod-02_instrukcja.indd 34 27-01-09 21:52:24