MPM MOD-02 - Manual (Page 29)

29
GB
F. Washing tip. It is used for sucking liquids from carpets, rugs and floors. This attachment
also sprays a washing liquid. In case of hard floor surfaces the washing tip must be used
together with an attachment.
F1 – Washing tip.
F2 – Attachment for hard surfaces.
G. Tip for delicate wet washing. This tip is suitable for cleaning furniture upholstery, curta-
ins etc. and for sucking liquid from narrow areas.
G1 - Tip
H. Additional accessories.
H1 – Handle used to fasten accessories
H2 – Attachment for cracks
H3 - Round brush
H4 – Narrow brush
H5 – Carpet and floor hand
H6 – Air refresher
H7 – Shampoo
BEFORE USE
Attention: Make sure that the device is disconnected from mains.
Disconnect a short washing hose (C2), located between washing liquid container (C1) and -
engine’s set and carefully take it from the connector (A3) (drawing 1,2).
Disengage the clamps (B6) (drawing 3). Lift an engine’s set with the use of fixed handle -
and take water filter tank off (B2).
Next take accessories out and put them in the handle (H1). -
During unpacking check if there are all parts and if they are not damaged. -
Release locks (D3) from the base and lift water filter container (B1) and washing liquid -
tank (C1) (drawing 3).
Put wheels (D2) on the bottom part of a water container (D1). -
Make sure that a foam filter (A9) is fixed in a float chamber (A8) (drawing 4). -
Fix a water filter tube (B4) (drawing 9), through a rubber gasket (B8) (drawing 10). -
Next put washing liquid tank (C1) on a base (D1), fix the water filter container (B1) and -
block the locks (D3).
Next put the water filter tank (B2) on the water container (B1) (drawing 11). -
Put water filter sponges (B3) in the tank (B2). -
Put engine’s set on the container and fix using clamps (B6). -
To fix the sucking hose (E5), put a fastening element (E1) to sucking inlet (B8). -
mod-02_instrukcja.indd 29 27-01-09 21:52:23