Multichannel Systems Portable_ME-System Manual - Manual (Page 7)

3
2 Important Safety Advice
2.1 Important Safety Advice
Warning: Make sure to read the following advice prior to installation or use of the device and the
software. If you do not fulfill all requirements stated below, this may lead to malfunctions or breakage
of connected hardware, or even fatal injuries.
Warning: Always obey the rules of local regulations and laws. Only qualified personnel should be allowed
to perform laboratory work. Work according to good laboratory practice to obtain best results and to
minimize risks.
The product has been built to the state of the art and in accordance with recognized safety engineering
rules. The device may only
 be used for its intended purpose;
 be used when in a perfect condition.
 Improper use could lead to serious, even fatal injuries to the user or third parties and damage to the device
itself or other material damage.
Warning: The device and the software are not intended for medical uses and must not be used on
humans.
Malfunctions which could impair safety should be rectified immediately.
High Voltage
Electrical cords must be properly laid and installed. The length and quality of the cords must
be in accordance with local provisions.
Only qualified technicians may work on the electrical system. It is essential that the accident prevention
regulations and those of the employers' liability associations are observed.
 Each time before starting up, make sure that the power supply agrees with the specifications
of the product.
 Check the power cord for damage each time the site is changed. Damaged power cords should
be replaced immediately and may never be reused.
 Check the leads for damage. Damaged leads should be replaced immediately and may never
be reused.
 Do not try to insert anything sharp or metallic into the vents or the case.
 Liquids may cause short circuits or other damage. Always keep the device and the power cords dry.
Do not handle it with wet hands.
Requirements for the installation
 Make sure that the device is not exposed to direct sunlight. Do not place anything on top of the device,
and do not place it on top of another heat producing device, so that the air can circulate freely.