Multichannel Systems STG-Lite Manual - Manual (Page 13)

9
4 Use of STG-Lite
4.1 Welcome to STG-Lite
The STG-Lite software program connects to the stimulus generator via USB (2.0 High Speed)
cable. Changes made in the software are downloaded immediately, without the need for an
additional user command. There is an automatic TTL signal on the Sync Out 1 of the stimulus
generator together with each stimulation pulse. You can control voltage driven stimulation only.
The STG-Lite program has two main menus for two stimulation modes "wave" or "pulses".
Up to four channels can be controlled. The program features rectangular waves, ramps or sine
waves, single and paired pulses and pulse trains. You can use the virtual control dial to adjust
the stimulation parameters frequency, amplitude and DC offset.
Main Menu
STG-Lite features two main menus according to the stimulation modes "wave" or "pulses".
You can stimulate with waves or with pulses on one or on two channels. Controlling two or four
channels, the settings for the channels are independent of each other, but the stimulation mode
always applies to both or to all four channels.
Main Menu: Stimulation Pattern "Wave"
Main Menu: Stimulation Pattern "Pulses"