Multichannel Systems STG-Lite Manual - Manual (Page 5)

1
1 Introduction
1.1 Introduction
The software STG-Lite is supposed to be an alternative to the default program MC_Stimulus II
for the control of the basic features of the Multi Channel Systems stimulus generators.
The software controls up to four channels of the STG stimulus generators of the 2000, 3000 and
4000 series. STG-Lite requires an USB connection between computer and stimulus generator.
Therefore, it can not be used to control the stimulus generators STG1002, 1004 and 1008.
STG-Lite is not meant to replace MC_Stimulus II as control software, but for easy stimulation
patterns, STG-Lite can be used instead of MC_Stimulus II. It is less flexible but easier to use.
Warning: To avoid problems with the connection to the STG, do not run STG-Lite
and MC_Stimulus II at the same time.