Specifications – Airstream CLASSIC TRAILER User Manual

Page 95

Advertising
background image

I

I - 1

SPECIFICATIONS

SPECIFICATIONS

Note: All weights were made on prototype vehicles.
Your production trailer may vary. For the weight
specifications of your specific trailer read the weight
label and check the manufacturing tag on the side of
your trailer. For label location, see information under
“Loading” section of this manual.

The Unit Base Weight (UBW) and the Net Carrying

Capacity (NCC) is not the same as the Unloaded

Vehicle Weight (UVW) and the Cargo Carrying Capacity

(CCC) shown on the Trailer Weight Information tag in

your vehicle.

The UBW and NCC weights are for the base unit with

no options and fluids. The UVW and CCC on the Trailer

Weight Information tag are weights for the individual

vehicle as built with its options and certain water

capacities.

Gross Vehicular Weight Rating

(GVWR): is the

maximum permissible weight of this trailer when fully

loaded. It includes all weight at the trailer axle (s) and

tongue or pin.

Unit Base weight

(UBW): is the dry weight of the base

unit with bedroom group and w/o options or fluids.

Net Carrying Capacity (NCC): is equal to GVWR-UBW.

Gross Axle Weight Rating (GAWR): is the value specified

as the load carrying capacity of a single axle system, as

measured at the tire-ground interfaces.

Axle Alignment:

Toe In

0 - 1/8” (All Models)

Camber 0 - 1 _ ° positive (All Models)

Battery

12 Volt Deep cycle (All Models)

Tire Size

ST225/75R15 (All Models)

Tire Inflation (PSI) Cold

ST225/75RI5 LRD 65 psi

Wheel Torque

Aluminum - 100 Ft. Lbs.

Steel - 95 Ft, Lbs.

Hitch Ball Height

The proper height will vary according to the weight

you carry and the tires you use. However, checking the

height on your trailer is relatively easy:

1. With trailer on fairly level ground measure from

ground to bottom of frame, front and rear.

2. Adjust front jack until measurements are equal

3. Now measure from ground to the inside top of ball

coupler. This figure is the hitch height. The hitch ball

is then usually set _” to 1” higher, according to the

spring weight of your tow vehicle, to allow for it to

settle when the trailer is hitched up.

Advertising