AEG LAVAMAT 54840 - Manual (Page 37)

5. Open the porthole and remove the polystyrene block
fitted on the door seal.
6. Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets,
rugs etc.
Before placing it on small tiles, apply a rubber coating.
Never try to correct any unevenness in the floor by putting pieces of wood,
cardboard or similar materials under the machine.
If it is impossible to avoid positioning the machine next to a gas cooker or coal-
burning stove, an insulating panel covered with
aluminium foil on the side facing the cooker or
stove, must be inserted between the two appliances.
The machine must not be installed in rooms where
the temperature can drop below 0.
The water inlet hose and the drain hose must not be
kinked.
Please ensure that when the appliance is installed, it
is easily accessible for the engineer in the event of a breakdown.
Carefully level by screwing the adjustable feet in or out. Never place cardboard,
wood or similar materials under the machine to compensate for any unevenness
in the floor.
37 Installation
HEC0010
HEC007
132970011.qxd 23/04/2009 10.25 Pagina 37