Installation, Removal, Mounting the microphone – Alpine 68-21627Z13-A User Manual

Page 34: Caution

Advertising
background image

34

-EN

Installation

Caution

When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.

1

Remove the mounting sleeve from the main unit (refer to
“Removal” on page 34
).

* If the installed mounting sleeve is loose in the dashboard, the

pressure plates may be bent slightly to remedy the problem.

2

Reinforce the head unit with the metal mounting strap
(not supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (

*1

) already attached to the

vehicle’s chassis.

Connect each input lead coming from an amplifier to the
corresponding output lead coming from the left rear of the
CDE-133BT. Connect all other leads of the CDE-133BT according
to details described in the CONNECTIONS section.

Note

• For the screw marked “

*2

”, use an appropriate screw for the chosen

mounting location.

3

Slide the CDE-133BT into the dashboard until it clicks. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install the
detachable front panel.

1

Remove the detachable front panel.

2

Insert the bracket keys into the unit, along the guides on
either side. The unit can now be removed from the
mounting sleeve.

3

Pull the unit out, keeping it unlocked as you do so.

JAPANESE CAR

Note

• Secure the ground lead of the unit to a clean metal spot using a screw

(

*3

) already attached to the vehicle’s chassis.

Mounting the Microphone

For the sake of safety, mount the microphone in the following location.
• In a stable and secure location.
• In a location that does not inhibit safely driving the vehicle.
• Mount the microphone in a location where the driver’s voice can

easily be picked up.

Choose a location for the microphone that can easily pick up the driver’s
voice. Requiring the driver to move towards the microphone for
audibility causes a distraction that could be dangerous.

Detachable Front
Panel

Less than 35°

Dashboard

Mounting Sleeve (Included)

Pressure Plates*

This unit

*

2

*

1

Bolt Stud

Chassis

Ground Lead

Hex Nut (M5)

Metal
Mounting
Strap

Screw

This unit

Removal

Bracket keys
(Included)

This unit

*

3

Front Frame

Screws (M5 × 8)
(Included)

This unit

Ground Lead

Mounting Bracket

Advertising