Dual digital timer control – Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 User Manual

Page 13

Advertising
background image

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Operating Instructions

11

70400301

Figure 5

Dual Digital Timer Control

QT and RQ Control Suffixes

1. Select HIGH, MED, LOW or NO HEAT by

turning the temperature knob.

2. Set the HEAT TIME for the number of minutes

(from 0-60) desired.

3. Set the COOL DOWN TIME for the number of

minutes (from 0-15) desired.

4. Select reversing or nonreversing cylinder rotation

setting, if applicable.

5. Press and release START button to start tumbler.

Display will show minutes remaining before end
of cycle.

NOTE: One touch drying is available for repetitive
loads. If the START button is pressed while the
machine is in Idle Mode, when the display is dark,
the tumbler will repeat the last drying cycle. If the
cycle time is adjusted before the cycle is started, the
time displayed when the start button was pressed
will be used for future cycles.

IMPORTANT: To stop the tumbler at any time
during the cycle, OPEN DOOR. If the loading door
or lint panel door is opened during the cycle, the
heating system will shut off and the motor will stop.
To restart the cycle, both doors must be closed and
the START button must be pressed in.

If the load cools to 90° F before cool down time
expires, the control will flash “Lr” (load ready) in the
heat time display. If the door is not opened, the
tumbler completes the selected cool down time. If the
door is opened after reaching “Lr” temperature, the
cycle will be terminated.

NOTE: If display shows an error code, refer to
Error Codes
section.

6. When the cycle is complete, open door and remove

the laundry. Anti-wrinkle feature will tumble the
load without heat for 30 seconds every 2 minutes
for 1 hour OR until the loading door is opened.

NOTE: This machine includes an anti-wrinkle
extended tumble feature. After the drying cycle is
complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.

TMB2136N

TMB2136N

REVERSING MODELS

TMB2133N

NONREVERSING MODELS

Advertising