Bosch PHS8667 Haarglätter ProSalon SensorProtection - Manual (Page 14)

10
Robert Bosch Hausgeräte GmbH
10 en
Congratulations on purchasing this
Bosch appliance. You have acquired a
high-quality product that will bring you a
lot of enjoyment.
These operating instructions describe a hair
straightener.
Parts and operating
controls
1 Locking device
L
/
U
2 on/off switch
3 Temperature selector +/–
(min 100 °C – max 200 °C)
4 Display, illuminated
5 LED display for permanent ionisation
6 Sensor button, illuminated
7 Heating plates, flexibly mounted, with
sensor
8 Cord clip
9 Storage bag (heat-resistant)
10 Ionic nozzle
Operation
● Plug in the appliance and place on the
heat-resistant storage bag.
● Turn on with switch 2. The preset
temperature lights up on the display 4.
● The desired temperature can now be set
using the temperature selector 3 at inter-
vals of 10 between 100 °C and 200 °C.
● The appliance heats up, the preset tem-
perature flashes in the display. The appli-
ance is ready for use when the preset
temperature is illuminated and no longer
flashing.
Info: The appliance has a memory function.
If the hair straightener is plugged out and
then plugged in again, it automatically
activates the last temperature set.
The hair can be straightened again using
the selected temperature.
Recommended temperatures for espe-
cially gentle straightening and shine:
Hair type Structure Recommended
temperature
wavy healthy 160 °C
wavy damaged 150 °C
wavy unhealthy 140 °C
curly healthy 180 °C
curly damaged 160 °C
curly unhealthy 140 °C
very curly healthy 180 °C
very curly damaged 160 °C
very curly unhealthy 140 °C
This information was calculated under labo-
ratory conditions: settings for your own hair
may vary.
Colour saving: Colour protection and
longer-lasting colour only at temperatures
< 180 °C and at the recommended temper-
atures stated above.
Button lock
To make handling the appliance easier, you
can lock the buttons “+”, “–” and Sensor. If
the button lock has been activated, the set
temperature cannot be changed by acci-
dentally pressing the buttons.
● Set the desired temperature.
● Press and hold the “–” button for three
seconds.
● The button lock is activated, and the dis-
play shows the M symbol.
● To deactivate the button lock, press and
hold the “–” button again for three sec-
onds; the button lock symbol M disap-
pears.
Note: The on/off switch 2 can not be
locked.