Asus AP1720-E2 - Manual (Page 37)

2-17 ASUS AP1720-E2 barebone server
3. When released, pull up the drive bay lock bar. Underneath the lock bar
are two pegs that match the holes on the drive bay. This mechanism
secures the drive to the bay in place of screws.
4. While holding up the drive lock
bar, carefully insert a 5.25-inch
drive into the bay, until the back of
the drive aligns to the rear edge
of the drive cage.
5. Connect the IDE cable to the IDE
connector on the back of the
drive.
6. Connect a 4-pin plug from the
power supply to the power
connector on the back of the
drive.
Due to space constraints inside the chassis, do not insert the drive all
the way at this time. This will allow you enough space to easily connect
the drive cables.
IDE cable
Power plug
Drive bay holes
Lock pegs