Avery ALS 256 - Manual (Page 37)

33
C
ONTENTS
3.2 I
NSERTING LABEL MATERIAL
ALS
20x
256
GB
3.2.2 Inserting a label roll
WARNING!
Risk of injury due to moving and rapidly
rotating parts!
£ Before inserting the label roll, ensure that
the device is turned off at the main
switch.
£ Do not under any circumstances turn the
device on before the label strip is
threaded in completely.
Removing spent backing paper
Assuming backing paper has gathered on the rewinder
[32A] :
£ Press the release button [32B].
– The tensioning mechanism of the rewinder is
slackened.
£ Remove the rewound backing paper.
Removing glue residue
£ If necessary, clean the following components:
– Dispensing plate
– Deflection rollers
– Drive rollers
– Pressure roller
£ Follow the directions provided in section
“Maintenance and cleaning” on page 47.
Inserting a new label roll
£ Push the material roll [33A] onto the unwinder as far
as it will go.
£ Rotate the rotary knob [33B] in a clockwise direction
until the label roll sits tightly.
£ Run the label strip around the dancer arm as shown
in the figure [33C].
[32] A Rewound backing paper
B Release button
C Backing paper path
B
A
[33] Inserting the material roll – Part 1.
A
C
B