4 operation, 1 start-up and shutdown, 1 turning on the unit – Avery ALS 256 User Manual
Page 43: 2 starting label dispensing, Dispensing with a product sensor, Dispensing without a product sensor, 4 . 1 s t a r t - u p a n d s h u t d o w n, Ontents, Tart, Shutdown
39
C
ONTENTS
4.1 S
TART
-
UP
AND
SHUTDOWN
ALS
20x
256
GB
4.1.1
Turning on the unit
£
Set the main switch [44A] of the unit to ‘I’ (On).
– The following messages are displayed during the
start process:
(machine type and firmware version)
(the machine’s RAM, as well as the CF card’s
memory, if a card is inserted)
– Once switched on, the ALS 20x is in dispensing
mode; in other words, triggering the product sensor
will cause a label to be dispensed.
– You can find more information on the dispensing
mode in the section “Spendebetrieb” on page 18.
4.1.2
Starting label dispensing
Dispensing with a product sensor
Once switched on, the ALS 20x is in dispensing mode;
this means that triggering the product sensor will cause
a label to be dispensed.
Prerequisites:
– The label length must be specified.
– The product sensor must be connected.
– The sensors must be configured correctly
(PNP/NPN).
Dispensing without a product sensor
It is also possible to trigger the dispensing process
without a product sensor:
– The machine is in dispensing mode:
£
Press the
button.
– The machine is in configuration mode:
£
Press the
button briefly (less than two
seconds).
ALS204 RH:
V 1.00
Memory:
16 MB
Flashcard
48 MB
ONLINE
Label
0
[44] Main switch (A) of the ALS 20x
A
4
O
P E R A T I O N
4.1
START-UP AND SHUTDOWN