Identification of safety symbols, Safety rules, Warning – Poulan Pro PP258TPC User Manual

Page 4

Advertising
background image

4

IDENTIFICATION OF SAFETY SYMBOLS

WARNING:

Fire hazard. Never mix, pour, or store gasoline or

use the unit near a flame or sparks (including smoking, open flames, or

work that can cause sparks).

Use unleaded gasoline and two--stroke oil mixed at a ratio of

40:1 (2.5%).

Always stop unit and disconnect spark plug before clean-

ing or servicing.

SAFETY RULES

WARNING:

Always disconnect spark

plug wire and place wire where it cannot contact

spark plug to prevent accidental starting when

setting up, transporting, adjusting or making re-

pairs except carburetor adjustments.

Because a pruner is a high-speed wood-cutting

tool, special safety precautions must be ob-

served to reduce the risk of accidents. Careless

or improper use of this tool can cause serious or

even fatal injury.

PLAN AHEAD

S

Read this manual carefully until you

completely understand and can follow all

safety rules, precautions, and operating

instructions before attempting to use the unit.

S

Restrict the use of your pruner to adult users

who understand and can follow safety rules,

precautions, and operating instructions found

on the unit and in this manual.

SAFETY INFORMATION

ON THE UNIT

INSTRUCTION

MANUAL

S

Keep all parts of your body away from the

chain when the engine is running.

S

Do not handle or operate a pruner when you

are fatigued, ill, or upset, or if you have taken

alcohol, drugs, or medication. You must be in

good physical condition and mentally alert. If

you have any condition that might be

aggravated by strenuous work, check with

doctor before operating a pruner.

If situations occur which are not covered in

this manual, use care and good judgment. If

you need assistance, contact your authorized

service dealer or call 1-800-554-6723.

OPERATE YOUR PRUNER SAFELY

S

Operate the pruner only in a well-ventilated

outdoor area.

S

Do not use a pruner to cut down trees or any

portion of the tree trunk.

S

Only use for pruning limbs or branches

overhead not greater than 6 inches (15 cm)

in diameter.

S

Do not cut small brush and saplings with the

pruner. Slender matter may catch in the

chain and be whipped toward you, pulling

you off balance.

S

Make sure the chain will not make contact

with any object while starting the engine.

Never try to start the unit when the guide

bar is in a cut.

S

Do not put pressure on the pruner at the end

of the cut. Applying pressure can cause you

to lose control when the cut is completed.

S

Do not run the unit at high speed when not

pruning.

S

If you strike or become entangled with a

foreign object, stop the engine immediately

and check for damage. Have any damage

repaired by an authorized service dealer

before attempting further operations.

S

Do not operate a pruner that is damaged,

improperly adjusted, or not completely and

securely assembled. Always replace bar

and chain immediately if it becomes

damaged, broken or is otherwise removed.

S

Always stop the unit when work is delayed

or when walking from one cutting location to

another. Stop the engine before setting the

unit down.

S

Use only in daylight or good artificial light.

S

Use only for jobs explained in this manual

(or manuals for optional attachments).

Advertising