PROLiNK PPL1201 User Manual - Manual (Page 27)

PROLiNK PPL1201 User Manual www.prolink2u.com
Version 1.00 Page 22 of 25 PPL1201
Device C wants to join an existing network group AB：
Step 1: Hold down the Pair button of device C for more than 10 seconds until both the Powerline and
Power LED are off, then release the Pair button. The Power LED of device C will start blinking.
Step 2: Then hold down the Pair button of device (A or B) for 2 seconds.
Step 3: Hold down the Pair button of device C again for 2 seconds
Note: This must be done within 120 seconds after pressing the Pair button of device (A or B).
Step 4: Wait for the Power LED of device C and device (A or B) to light up. Now you will have device A join
the network group BC.
5.3 Pair Button Behavior
The following table summarizes the actions that occur when the Pair button is pressed for specific time.
Pair button Action Status Power LED Light Behavior
less than 3 seconds The adaptor joins a network. It
shares the same network name as
other adaptors on the Powerline
network. The Power LED turns on if your
adaptor is connected to another
Powerline adaptor or a Powerline
network.
more than 10 seconds
The adaptor leaves any network it is
associated with and its network
name assumes a random value. The Power LED turns off when it
disconnects from the Powerline
network.
5.4 Reset
Restore the Powerline adaptor configuration to factory default.
a. Please make sure unplug (remove) the Ethernet cable first, and then press the Reset button.
b. Hold down the Reset button for 2 seconds. The default settings have been restored.
Be careful, don’t power off when the device is in reset process.
Section 5 Section 5