PROLiNK Hurricane 9000G - Manual (Page 33)

Chapter 3 Configuration
29
DHCP Server
DHCP Server: Check DHCP Server to enable the router to distribute IP Addresses, subnet mask and
DNS setting to computers. Hence, the following fields will be activated. If you do not check this selection,
remember to specify a static IP address, subnet Mask, and DNS setting for each of your local computers.
Be careful not to assign the same IP address to different computers.
DHCP address pool selection: Auto or User Defined. If select the AUTO, router will assign an IP
address back to PC’s IP request. If User Defined, please specify the IP pool range.
User Defined Start Address: Enter the start address of this local IP network address pool. The pool is a
piece of continuous IP address segment. The default value is 192.168.1.100.
User Defined End Address: Enter the last address of this local IP network address pool that you want
the DHCP server to assign IP addresses to. The default value is 192.168.1.199.
With this case, the DHCP pool is from 192.168.1.100 to 192.168.1.199. Therefore, the local computer will
get an IP address located at this range randomly.
Lease Time: Set the lease time you required.
User Mode: There are two selections, Single User and Multi-User, for this setting.
3.4.3.3 Wireless
3.4.3.3.1 Basic setting
SSID : Enter the unique ID given to the Access Point (AP) built in the wireless broadband firewall
gateway. To connect to this device, your wireless clients must have the same SSID as that of this device.
Channel : Select the ID of channel you would like to use.
Security: Select Enable or Disable the function of Encryption to establish more secure environment for
wireless data transmission.