PROLiNK Hurricane 9000G - Manual (Page 41)

Chapter 3 Configuration
37
Active: Choose “Yes” to enable the rule, or choose “No” to disable the rule.
Packet Type: Specify the packet type (TCP, UDP, ICMP or any) that the rule will be applied to.
Select TCP if you want to scope for the connection-based application service on the remote server using
the port number. Or select UDP if you want to scope for the connectionless application service on the
remote server using the port number.
Log: Choose “Yes” if you want to generate logs when the filer rule is applied to a packet.
Action When Matched: If any packet matches this filter rule, Forward or Drop this packet.
Source IP Address: Enter the incoming or outgoing packet’s source IP address(es).
Source Port: Check the TCP or UDP packet’s source port number(s).
Destination IP Address: Enter the incoming or outgoing packet’s destination IP address(es).
Destination Port: Check the TCP or UDP packet’s destination port number(s).
If the DHCP server option is enabled, you have to be very careful in assigning the IP
addresses of filtered private IP range in order to avoid conflicts because you do not know
which PC in LAN is assigned to which IP address. The easiest and safest way is that the
filtered IP address is assigned to specific PC that is not allowed to access outside
resource such as Internet. You configure the filtered IP address manually to this PC, but it
is still in the same subnet with the router.
3.4.3.5.2 Bridge Filtering