Alliance Laundry Systems UF35PV User Manual

Page 37

Advertising

Programming

F232059

25. An extract step should now be programmed.

a. Press the Medium Speed key. The display will

read “MS1139”, indicating a medium-speed
spin.

b. Press the Enter key. The display will read

“M---S”.

c. Enter the length of time for the medium-speed

spin (one minute).

Press key 1. The display will read “1M-00S”.

26. Press the Enter key. The display flashes “SDLY”

for one second. It will then read “0M-00S”,
allowing the programmer to enter the time for a
slow down delay (coast).

At some point in the future – to have the basket
coast before it stops – enter the desired coast time
(up to 99 seconds). However, do not enter a time
now. That would cause a coast before a higher
spin speed (which will be the next step).

For no coast, press the Enter key.

27. The next step is to program a high-speed 1 spin,

the lowest of three high speeds. (Pressing the
High Speed key repeatedly when programming a
high-speed step will cause the computer display
to proceed from “H1” to “H2” and then to “H3”,
the maximum-speed spin. After “H3” appears
and the High Speed key is pressed again, “H1”
will reappear.)

a. Press the High Speed key once. The display

will read “H11239”.

b. Press the Enter key. The display will read

“M---S”.

c. Enter a length of time for the high-speed spin

(six minutes). Press key 6. The display will
read “6M-00S”.

NOTE: High-speed spin is not preceded
automatically by medium-speed spin. Medium-
speed spin only or high-speed spin 1, 2, or 3 may be
programmed.

28. Press the Enter key. The display will flash

“SDLY” for one second. (“SDLY” also displays
during the entire actual coastdown.) The display
will then read “0M-00S”, inviting the
programmer to enter a time for the slow-down
delay (coast). If the application requires that the
basket coast before it stops, enter the desired
coast time (30 seconds here) and press the Enter
key. If no coast is desired, press the Enter key
only. The display will read “1339”.

NOTE: A slow down delay of 30 seconds minimum
should be programmed after each high-speed spin
if the speed is not followed by a higher speed spin
or another spin at the same speed. Longer motor
and belt life are direct benefits. All the
preprogrammed and optional cycles in this manual
reflect this practice.

29. The previous step ends the tutorial. Cycle 39,

consisting of 12 steps, has been completely
programmed.

To end the cycle, turn the Program Mode switch
located on the left side of the control module to
the RUN position and remove the key. The
display will then read “NEXT”.

The programmer can now select Cycle 39 and
press the Enter key to run the cycle, if desired; or
a cycle of the programmer’s own design can be
programmed.

Table 3

Tutorial Cycle

Step

Description

Min:sec

Hot Fill to Low Level