SPP Pumps Auto Prime Q Series - Workshop Manual - Manual (Page 19)

Workshop Manual for
AUTOPRIME Q Range Pump Unit
Manual No/Rev
W72-021E / 8
Our policy is one of continuous improvement and we reserve the right to alter specifications at any time
Page 19 of 36
7.5 Vacuum Pump Assembly
7.5.1 Vacuum Pump Parts Diagram
1
10
2 3 11
10
11
4
5
6
7 9 8 9
13 12
15
16 17
18
19
22
23
24
25 26 27 28
21
28
12 13 14
20 - MAGNETIC CLUTCH ASSY
29 30 31
DIRECT DRIVE PULLEY
65cfm BD @1
7.5.2 Vacuum Pump Parts List
ITEM DESCRIPTION PART No QTY
1 Stator 13695.123 1
2 Rotor 13692.165 1
3 Bearing NDE 14068 1
4 Bearing DE 14067 1
5 Endplate NDE 13694.123 1
6 Spacer 15488 1
7 Stud M10 x 40 SY9509093 6
8 Stud M10 x 25 SY9509087 6
9 Dowel - 6MM x 25 21123-478-347-4 4
10 ‘O’ Ring 18079 2
11 ‘O’ Ring 18078 2
12 Nut M10 21882-673-958-3 15
13 Washer Spring M 10 21174-306-927-6 15
15 Vane 14132 4
16 Lip seal 18080 1
17 End plate DE 13693.123 1
18 Wave spring washer 14069 1
19 Key 13986 1
20 Magnetic clutch assy. 13777 1
21 Plug male 1/8” Solid SY9209159 1
22 Grub screw M10 x 12 21828-170-977-9 1
23 Grub screw M12 x 16 21828-212-977-6 1
24 Shim pack 15730 1
25 Stud M10 x 25 SY9509087 3
26 Connection inlet 13699.123 1
27 Gasket 14075 1
28 Rapid fitting 14008 2
29 Pulley – Direct drive 19131 1
30 Washer 19099 1
31 Screw 19098 1
7.5.3 Vacuum Pump Assembly Instructions
1. Fit bearing to rotor (DE). Use blocks to
raise rotor and fit the inside of the other
bearing. (NDE)
2. Fit the spacer and 0.003” shim into the bore
of the NDE cover plate.
3. Place the rotor into the bore and spin.
Check the gap between the rotor and plate
using a feeler gauge.
4. Fit M10 grub screw to the base to plug hole.
Place rotor inside stator.
5. Adjust plate so that rotor is not rubbing
against stator wall. Fit M10 x 25
6. Fit 6 M10 x 40 studs to stator on NDE and
fit dowel and O-Rings. Fit stator and non-
drive end plate together using M10 nuts
and flat washers.
7. Oil the vanes and slide them into the stator
on the drive end.
8. Fit the lip seal into the DE plate. Note that
the lip seal is to be fitted with the lip and
spring facing outward to prevent ingress of
dirt and air.
9. Place the wave spring washer and the rest
of the bearing into the bore of the plate.
10. Fit the plate to the stator, ensuring that the
dowel is located.