Operations 2 – Teledyne TED-60 - Medical application oxygen monitor User Manual
Page 9
Operations 2
Operations 2
Operations 2
Operations 2
Operations 2
2-1
Teledyne Analytical Instruments
Operations
s
s
s
s
CAUTION:
CAUTION:
CAUTION:
CAUTION:
CAUTION: UPON RECEIPT, INSPECT THE ENTIRE UNIT FOR DAMAGE. CHECK UNIT
UPON RECEIPT, INSPECT THE ENTIRE UNIT FOR DAMAGE. CHECK UNIT
UPON RECEIPT, INSPECT THE ENTIRE UNIT FOR DAMAGE. CHECK UNIT
UPON RECEIPT, INSPECT THE ENTIRE UNIT FOR DAMAGE. CHECK UNIT
UPON RECEIPT, INSPECT THE ENTIRE UNIT FOR DAMAGE. CHECK UNIT
AND INCLUDED ACCESSORIES FOR BROKEN OR LOOSE PARTS. IF DAM-
AND INCLUDED ACCESSORIES FOR BROKEN OR LOOSE PARTS. IF DAM-
AND INCLUDED ACCESSORIES FOR BROKEN OR LOOSE PARTS. IF DAM-
AND INCLUDED ACCESSORIES FOR BROKEN OR LOOSE PARTS. IF DAM-
AND INCLUDED ACCESSORIES FOR BROKEN OR LOOSE PARTS. IF DAM-
AGED, DO NOT USE; NOTIFY THE SHIPPER; AND CONSULT TBE SENSOR
AGED, DO NOT USE; NOTIFY THE SHIPPER; AND CONSULT TBE SENSOR
AGED, DO NOT USE; NOTIFY THE SHIPPER; AND CONSULT TBE SENSOR
AGED, DO NOT USE; NOTIFY THE SHIPPER; AND CONSULT TBE SENSOR
AGED, DO NOT USE; NOTIFY THE SHIPPER; AND CONSULT TBE SENSOR
TECHNOLOGIES.
TECHNOLOGIES.
TECHNOLOGIES.
TECHNOLOGIES.
TECHNOLOGIES.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: This equipment is internally powered.
This equipment is internally powered.
This equipment is internally powered.
This equipment is internally powered.
This equipment is internally powered.
Setup
To set up and use your TED 60T:
1
1
1
1
1
Install the battery.
2
2
2
2
2
Install the sensor.
3
3
3
3
3
Calibrate the unit.
Battery Installation or Replacement
Battery Installation or Replacement
Battery Installation or Replacement
Battery Installation or Replacement
Battery Installation or Replacement
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: A 9-volt alkaline battery must be installed in the unit before the TED 60T can
A 9-volt alkaline battery must be installed in the unit before the TED 60T can
A 9-volt alkaline battery must be installed in the unit before the TED 60T can
A 9-volt alkaline battery must be installed in the unit before the TED 60T can
A 9-volt alkaline battery must be installed in the unit before the TED 60T can
operate.
operate.
operate.
operate.
operate.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: When new batteries are installed, typically, the unit is suitable for use immedi-
When new batteries are installed, typically, the unit is suitable for use immedi-
When new batteries are installed, typically, the unit is suitable for use immedi-
When new batteries are installed, typically, the unit is suitable for use immedi-
When new batteries are installed, typically, the unit is suitable for use immedi-
ately after installation.
ately after installation.
ately after installation.
ately after installation.
ately after installation.
1. Turn the unit off (if it is on).
2. Open the battery compartment door. (The battery compartment is below the
belt clip on the rear of the unit. The door slides downward in the direction of
the arrow.)
3. Lift the battery from its compartment and unsnap it from the snap connector.
4. Snap the new battery to the snap conector. (Match up the male and female
snaps. The battery snap connector will only accept a properly oriented
battery. Do not try to force it.