Bosch KDN64VL20N Frigo-congelatore da libero posizionamento Inox look - Manual (Page 17)

en
17
Proceed as follows:
1. Before cleaning the appliance, unplug
the mains plug or disconnect the fuse.
2. Take out the frozen food and store it in
a cool place. Place an ice block (if you
have one) on the food.
3. Clean the appliance with a soft cloth,
lukewarm water, and a little pH-neutral
detergent. The water used for rinsing
must not get into the lighting.
4. Only wipe the door seal with clean
water and then rub it until it is dry.
5. After cleaning, reconnect the
appliance to the mains and switch it
on.
6. Put the frozen food back in.
Features
To clean the appliance, all of the variable
elements can be removed.
Removing shelves
Lift the shelf and move it towards the
front.
Removing the door shelves
Lift the door shelf and remove it.
Lighting (LED)
Your device is equipped with a
maintenance-free LED light.
Any repair work on the lighting must only
be carried out by the after-sales service
or authorised experts.
Saving energy
■
Install the appliance in a dry,
ventilated room. The appliance must
be installed out of direct sunlight and
away from heat sources (e.g. heating
elements, cooker).
Use an insulating plate if necessary.
■
Allow hot food and drinks to cool
before placing them in the appliance.
■
Place frozen food that is to be
defrosted in your cooling
compartment. Use the low
temperature of the frozen food to cool
down food.
■
Open the appliance door for as little
time as possible.
■
Clean the rear side of the appliance
occasionally with a vacuum cleaner or
brush in order to avoid increased
power consumption.